Answer Posted / wareagle
HB: slow burning on a horizontal specimen; burning rate <
76 mm/min for thickness < 3 mm.
V2 burning stops within 30 seconds on a vertical specimen;
drips of flaming particles are allowed.
V1: burning stops within 30 seconds on a vertical
specimen; drips of particles allowed as long as they are
not inflamed.
V0: burning stops within 10 seconds on a vertical
specimen; drips of particles allowed as long as they are
not inflamed.
5VB: burning stops within 60 seconds on a vertical
specimen; no drips allowed; plaque specimens may develop a
hole.
5VA: burning stops within 60 seconds on a vertical
specimen; no drips allowed; plaque specimens may not
develop
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is ps impedance test
why -48 volts dc used in telecommucation
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
How can we convert 11 kv to 440 volt without using transformer ?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
why we cannot protect 100% winding of an alternator by using differential protection?
How to calculate the sag on transmission Lines.
how to discharge 3 phase power factor correction capacitors
IN dc capacitive reactance is??
What is the main use of rotary phase converter ?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
Plz tell me how we can find that particular company has vacancy or not
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?