Answer Posted / janmayjay
device to convert dc to ac
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
What is the unit of magnetic flux density?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
Where can i get practical knowledge of solar system?
what is plunger and what's the use of it in motor alignment?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
how much LT load can bear by the 100 KW HT connection.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
how to work droop ct in generating station
low frequency protection why recomend?
how to select the double earth conductor if 21A full load?