Why we called L-G fault as line to ground fault why ground?
suppose if a line falls on building roof then can we called
these fault as line to roof fault? please explain why
ground term is used here?
- 3 Answers
- 4892 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / pandeyrahul
ground means reference voltage, it does not mean it should
be 0 v or on the ground
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Please explain, how to test vector group of tranformer(Delta y1) . Thank
what is earthing transformer? draw the winding dia.of earthing transformer.
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Why the output of OP-AMP is always less than Vcc?
what is the voltage regulation for unity and zero power factor?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
define the non synchoronism of synchoronous machine in general g or m??
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
which VFD is better ( LT or HT)
Which Class insulation is prefered for the sandwich Busducts ? Why?
can anyone show me how the 3 phase power is supplied to socket outlets?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
