Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / inst
digtal outputs
command which is given from plc,dcs to the respective field
ex:i have to on motor
command which is given to on motar is do
and we have check weather it got on r not that is status
which is getting to plc is digital input
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is hp & mp seperator .& what is its working principle ?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
which type of signal used in instrument?
you are on site,the plant trips,you are approached by operations,what do you do?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Draw bode plot of any transfer function. Why is plotting bode necessary?
Explain pH, Conductivity.
Explain about the leakage class of the control valves
What is offset in a control system.
please send data bank of quetions answers on analytical instrumentation.
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
