Radio Carbon dating is used in
a) find diseases
b) find the age of relics
c) find the carbon content in the atmosphere
d) none of these
Answer Posted / teninlo
to find the age ofrelics
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
When can we take Neutral as common neutral link?
How to work meggar?
what is the question paper model for section engineer in RRB
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
Show the schematic arrangement of diesel power station layout and give its principle of operation.
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
which metal is use in shunt
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
mccb service sittings be done?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.