Answer Posted / ab_ina7
to create the sufficient vaccum in the eye of impeller to suck the water and also to avoid cavitation due to entrapped air
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What do you understand by critical points in iron, iron-carbide diagram ?
What are the advantages of a centrifugal pump over a reciprocating pump?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
Why rate of condensation is higher on a polished surface compared to rusty surface ?
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
How to handle production department ?
pls tell me the process to set up a power plant right from the permission from state govt ????
What is the Self & starter? what does it do in the in Genset
Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?
Who invented the four-stroke engine?
pls send me HPCL model question paper for the post of officer trainee for mechanical engg. tnk u....
Write down the equation for conduction of heat through a slab or plane wall.
What are the different values that need to be determined in order to design a cylinder for an ice?
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
why study in Michigan tech univ