Answer Posted / raj kumar
Power Factor is ratio of KW/KVA means it show angle between
current and Voltage.
Ex. When you are looking reading on meter that is 500 KW
AND 560 KVA and Power factor looking 98.0 then u can think
u r using 98% load of kw and u r loosing 2 % load.
Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Igfet is a
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
what is the difference between skin effect
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
along with technical test papers
Explain the operation carried out in thermal power stations?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
why the neutral point in connnection oscillates?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
how to test reverse power trip?
I want to know Electrical Circuit?
Why the output of OP-AMP is always less than Vcc?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?