Interested to Buy Any Domain ? << Click Here >> for more details...
what is coriolis principle for mass flowmeter?
- 5 Answers
- 14312 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / omak
If there is no flow then no coriolis effect, if there is a flow then it will make coriolis effect. In coriolis flow meter, consists of two parellel flow tubes connected with a drive coil and two magnetic pick ups on either side of the tubes. During no flow condition, the drive coil makes a small vibratio in the tubes one another. Due to this vibration the magnetic pickoff coil will generate a voltage equilant to a sine wave. In this condition sine wave created by both the inlet and outlet magnetic pick up is same.
During in flow condition, then there is a twisting in the flow tube. In the inlet side the flow opposes the vibration and in the outlet side the flow adds the vibration and makes twistinh in the flow tube. Due to this twisting the pickoff coil makes different sine wave output. By measuring the phase shift with reference time will be calculated as t in micro seconds. Multiply t with the calibration factor, we will get the mass flow in grams/sec.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
What are the interlocks we have to check during the start up of LP/HP compressor?
give some question relative instrument fitter?
Why plc require in analog input 4-20amp & 0-10 volt?
How many interlocks at turbine? Plz explain briefly
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
use of split range ? where it is used ? in which control loop it is used ?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Name different parts of a pressure gauge.
Why do we floating DC in DC system.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is offset in a control system.
what is interface level and how it is calibrate?
What are different types of control valves?
