Interested to Buy Any Domain ? << Click Here >> for more details...
Give the selection criteria of a 3 Phase transformer for
industrial purposes ?
- 5 Answers
- 12196 Views
- NDDB, TATA, I also Faced
- E-Mail Answers
Answer Posted / deepankar
These points must be
taken into account...
~voltage required
~transformer
connection
~total connected load
~demand factor
~1.5 times safety factor
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
can we conduct the swineburne's test on a dc series motor? why?
what are the interview question asked in wind mill about electrical
why is the conservator tank painted white on the transformer
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
How to setting the volume of RTCC panel AVR (11kv) controller
How much voltage we need to apply in 33kv cable during hipot test of cable
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What is meant by time harmonics and space harmonics?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
What is cathode ray oscilloscope (cro)?
What is the permissable nutral current of three phase system as per IS standards?
