Interested to Buy Any Domain ? << Click Here >> for more details...
In all analog voltmeters or ammeter showing some small size
symbols. as well as a star and in star 2no. digit, resister
symbol,and other. what is that's meaning ?
- 1 Answers
- 14967 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendra paudel
If 2 no. digit is inside star that means dielectric test voltage is above 500 ohm (2 kv). there is another symbol as a resistor that is moving iron .And other symbols as perpendicular means vertical dial(scale).
| Is This Answer Correct ? | 26 Yes | 1 No |
Post New Answer View All Answers
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
how to make an earthing certificate
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
What are reasond for high wattage in single phase induction motors
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
Give the topology of current amplifier with current shunt feedback?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
What is “pu” in electrical engineering?
in dc series motor if field wdg is shorted then
What is the difference between hot and cold loop testing?
