Interested to Buy Any Domain ? << Click Here >> for more details...
What is the full form of CNC in electrical mechines.......?
- 1 Answers
- 8510 Views
- Alstom, I also Faced
- E-Mail Answers
Answer Posted / psingh
Computer Numeric Control system
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
what is the difference between surge protection capacitor and surge arrestor
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
Z transform is use when system is not a) converges b) diverges
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
What is the difference between solid grounding and impedance grounding?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
What is s-domain and its significance?
What are the commonly used schemes for the bus zone protection?
How one can check the MAIN of a house wiring ?
