if the power factor is .88 i want to increase the power
factor to .99 what number of capacitor is to add?
Answer Posted / bhadrappahr
The kVAR of capacitors necessary to raise the power factor to
0.99 from 0.88 is found by using formula referenced above:
0.398 x 50 kW = 20kVAR
this also depends on at what load are we used
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
how is the incoming cable size calculated for a given current rating of a panel??
Why does the adjacent zone of protection overlap?
what will happen if i connect 12 volt battery with 24 volt battery charger.
list the type of vfd? wich is sutable for heating kiln?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
How to minimize the eddy current losses?
What's mean HVF & HAF in Vacuum Circuit Breaker?
area control error
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?