Interested to Buy Any Domain ? << Click Here >> for more details...
circuit breaker work alone during fault condition or need
any relays ?
- 4 Answers
- 6105 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak yadav
yes, relay is used in circuit breaker for automatic opration. without relay it is oprated manually
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How it can worked plc based electrical system And which type of software using.
What is q factor?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
Explain what is use of lockout relay in ht voltage?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
what is the basic need of domestic loads 1- voltage 2- current
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
how to make an earthing certificate
Explain what is electric traction?
Define peak overshoot.
