Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naveen chandra shekhar
The microprocessor based distributed digital control,
monitoring & information system(DDCMIS)shall provided
for the safe and efficient operation of SG, TG, balance of
plant and all auxiliaries in all regimes of Operation.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
How to Calibrate Flammable gas detector in field
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
How to work temperature gauge?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
send me last 5 years questions asked in rrb chennai, for section engineer
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
how to work MIL contol valve posistioner ?
What is instrumentation control?
Coal mill Instruments Equipments for cement plant And process diagram ?
Why do we have earthing cable in branch cable and shield in the same cable?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
