what is voltage rise and voltage drop?
- 8 Answers
- 48234 Views
- HP, jetking, TCS, I also Faced
- E-Mail Answers
Answer Posted / sas
When a voltage is generated in any device or in any part of
a circuit, the point of positive potential is said to be at
a higher potential than the point of negative potential. The
means by which the voltage is generated is said to produce a
voltage rise, and the rise is designated by the letter E. In
some instances the instantaneous value of a changing voltage
rise may be under consideration and it will be designated by
e. When the circuit is completed, as in Fig. 3-1, the
available voltage E forces a current through the remainder
of the circuit and there is said to be a voltage drop
through that part of the circuit. Drop in voltage is
designated by the letter V.
| Is This Answer Correct ? | 8 Yes | 10 No |
Post New Answer View All Answers
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
can we install HT panel & LT panel side by side or how much clearance is required ?
Why temperature rise is conducted in bus bars and isolators?
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
TRANSFORMERS WITH DC SUPPLY
what is the need of starter in tube light and what type of starter is used in that?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
