Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if i install my pressure transmitter below the elevation of pipe in natural gas service. Also support your answer
- 3 Answers
- 9192 Views
- C2C, I also Faced
- E-Mail Answers
Answer Posted / aftab ahmed mazari
Pressure will be added up a bit more, see its detail:
1. Suppose,you want to install a pressure transmitter 10
meter below of pipe line.
2. Density of methane (Examlpe) 0.656 kg/m3 at 25C.
3. your pressure transmitter will show (10 x 1000 x0.656 =
6560mm) 6569 mm of water pressure more.
4. Suppose gas pressure is 20Kg/cm2, then due to this
elevation, transmitter will show 20.66Kg/cm2
aftabmazari@yahoo.com
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What is zero elevation and zero suppression?
selection criteria of control valve? and selection criteria of actuator explain in brief?
which type inter lock use in petrochemical refinery,and oil & gas?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
principle of dead weight tester ?
Using your own examples solve a problem involving normal table. (experimental method and analysis)
What is the purpose of LO Overhead tank in turbines.
please tel me the calibration of pneumatic controler.
What is zener diode? What is voltage regulator?
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what about your moleg in pogrees with company
What is the use of GMV in turbine?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
