Interested to Buy Any Domain ? << Click Here >> for more details...
in a plug point why the hole size at the top is large?
- 9 Answers
- 14027 Views
- Bhel, TCS, I also Faced
- E-Mail Answers
Answer Posted / pkb
Top point is for earthing. The hole size is large (1) to
flow fault current which is very large (2) secondly to
distinguish between phase and neutral point.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Define characteristics impedance?
How much dc volt applied in cathodic protection system?
Define ampere
which type of cabel
Ac generato how produce power I need for camplet defination
does a DG set has low fault level as compared to that of a transformer.If yes then why.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What can you contribute to the progress of our Company as an employee if you are selected?
what is meant by skew width in machines?
Differentiate between low pass, high pass and band pass filter?
thyristor controlled APFC panel design parameter?
Why you want to join non technical field when you are an engineer?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
Batteries. What is the difference between Lead and Nickel batteries ?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
