Interested to Buy Any Domain ? << Click Here >> for more details...
what is unit of
inductance
- 12 Answers
- 16460 Views
- Bhel, Bosch, OSML, Vijai Electricals, Voltage, I also Faced
- E-Mail Answers
Post New Answer View All Answers
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
what is the minimum voltage require to injure our body?
use of choke in APFC panels
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what are the range of memory address in plc for L&T lx7 4A
What are the advantages and disadvantages of short-pitched winding?
why constant voltage transformer should be start without load? and if started then what will happen?
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
what will happen if i connect 12 volt battery with 24 volt battery charger.
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
'documenˁ
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
how we explain parallel paths armature winding?
