what's the use of
cvt and wave trap
in 400kv switch
yard.......
Answer Posted / amit bansod
In 400KV switch yard CVT and WAVE TRAP is used
Because CVT is use for menataing the 400KV voltage and also use for
Synchronising the,bus to line or feeder
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why High voltage are generate noise ?
how to control the speed to switched reluctance motor
how to erect roof control panel?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
What is meant by cold loop test in instrument
state types of reflectors in illumination engg. ???????
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
Why do we require transformer with less specific weight if supply frequency is increased?
Please define ohm’s law for a.c (alternating current)?
Name the component u would expect to find in a switchgear assembly?
What are the commonly used schemes for the bus zone protection?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
How earthing of switchgear system to be done.
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks