Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nikunj
Cryogenic means to work in lower temperature range (-50 and
below than that).
Nikunj
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
Why trim span ? How?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
what would be the minimum flow rate that we can measure on rotameter..?
why we are using magnet for calibration of gas detector?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
Why even multiple power supplu r used in instrumentation system?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Is there any relation between Artificial Intelligence and Instrumentation?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
Introduce yourself which is not present in your biodata?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
