Interested to Buy Any Domain ? << Click Here >> for more details...
Bus-bar is made of which material & name of mostly used
material in bas-bar design ?
- 7 Answers
- 27135 Views
- I also Faced
- E-Mail Answers
Answer Posted / sennapparajan
copper is the dedicated material for busbars. for reducing
cost people using aluminium also.aluminium having low KA
rating capacity.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
What is the ratio of Booster transformer?
what is mean by parallel operation of permanent magnet generators
which type of stability limit is higher,steady state or transient? why?
Why is back emf used for a DC motor? Highlight its significance.
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
How to synchronization will be done between two DGs ?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
how rectifier transformer work in electroststic precipetatore(esp?
