Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nagarjuna jaladi
The speed of electricity refers to the speed of
electrons,which varies with the amount of potential
difference under the influence of which they are moving.
Hence the speed varies and is not fixed.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
How to calculate wire length,size & current? ( related to control panel)
how can check the resistance of battery contact?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
how slip power recovery system work
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
What is depreciation factor?
What is the formula of frequency ?
what is meant by IGBT how they differ from tyristor ?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
How much ph is maintained of water resistance starter for slipring induction motor ?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
