Interested to Buy Any Domain ? << Click Here >> for more details...
Hello friends, Can anyone explain the concept of zones in
Bus bar protection and how can we differentiate the main
zone and check zone in Bus bar protection
- 1 Answers
- 8763 Views
- ABB, NCC, I also Faced
- E-Mail Answers
Answer Posted / veldhaya
hi dear,
Zones are classified on the basis of factors like
1.Bus sectionaliser
2.Bus coupler
We can differentiate the Main zone & check zones using
Main zones need to monitor both the Current input & the Isolator input of a particular bay whereas Check zones need to monitor the Current input of a particular bay.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
application s to shunt coil
What is transister define the transister ammiter ,base, colector.
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
what is W.T?specify the acceptable range?
what happen when increase or decrease size of lamp,light.glass.
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
Explain Energy and Power signals?
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
What is pi controller?
What is oscillator circuit?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
