Is there any calculation to find unknwon(unferroled) phases R Y B in alternator,3 phase motor anybody shoot my problem.
how can we notice this is the respective phase?
- 2 Answers
- 3428 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
phase sequence is important. If any phase of gen is
synchronized with R phase of the system ,then that phase
becomes R phase.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
what are the types of electromagnetic forces developed in practical transformer?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
What happens if we connect a single phase energy meter in reverse polarity.
what is meant by skew width in machines?
What is the difference between vector surge relay (78) and Pole slip relay (98G)
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
power transmission pole used one support , that only for support or earthing
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What is sensitivity of a measurement?
