suppose we have a tendency to make a hole on the surface of
the beam, than where we goes to make it?
Answer Posted / ashutosh
in the design of RCC beam we design it as a crack section neglecting the area of concrete below the neutral axis so we can make a hole in concrete in the area below the neutral axis .
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
a rectangle grill of length 72 inch x 20 inch width.how to calculate bar spacing ,bar consist 8 mm thickness and spacing of bar is 2 inch.. calculate no of bar with formula
what is the dimensions of river sand truck trailer or trolly ?
Whats the meanig of ,'K' VALUE in the case of soil.....
Dear Frds, How can i calculate the Steel for RCC Slab, Please provide one Example also, so that i can understand very well. Ex: Area: 1320.0 Sft.(44' X 30') Span: 15'(Default). Column Size: 9"X15"(6 No.s 12mm Rods) Please Provide Calculation Details. Thankyou. Satish
How high should the water tank be to provide a 60 psi at base of this water tower?
what is the minimum compressive strength of clay brick
what are the layers of the national and heir aprox thickness??
RR masonry rate analysis
in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh
What is the difference between engineering stress and true stress?
what is the quantity of block work required to construct a compound wall of 6" thick,and 212 lenght
what is the specific gravity of rubble in plum concert
Questions related to civil.engg in company
what is difference between NP2 NP3 NP4 CONCRETE HUME PIPES USED AT SITE
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.