Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aashish gambhir
SIL is the power transmitted when line is terminated
through a resistance equal to surge impedance......it is a
conctant value and characteristi of the line.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
What is the normal phase difference between the voltage and the no-load current in a transformer?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
wish of these transformer uses oil?
What is the suitable transmission voltage?
Salient pole alternator is more stable, why?
what is lrs tank water resistance.
Why are the cores of large transformers built up of circular transactions ?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
