Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference betwteen overcurrent and short
circuit fault?
- 3 Answers
- 6712 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh katakdhond
overcurrent means just harm equipment slowaly (20to50percent greater than actual current)
shortcicuit means harm suddenly on equipment(it will some multipal value to actual current(4,5,6,7,....*actual current)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
which pump used in STP
How many types of electrical earthing are there?
What is VCB? where it is installed at SP. What is SP?
Define noise?
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
why and where we use early make & late break contacts in protection?
What are the different methodes for calculating the short circuit Current?
why are u join ntpc
Can we Co-ordinate relay in Load Break switch?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
why the pf of semiconductor device is improved the electrical devices
What is contract demand in solar system?
as a electrical student why should i hire you?
how to find impedance , mutual indatnce in transmission lines
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
