Interested to Buy Any Domain ? << Click Here >> for more details...
how the fan is switched off immediately switching off the
switch?
- 2 Answers
- 4364 Views
- I also Faced
- E-Mail Answers
Answer Posted / bramhireddy
change the supply terminal when it comes to zero speed disconnect the terminals.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
Why do we use copper cable for HT Supply and why not Aluminium?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Define characteristics impedance?
What can you contribute to the progress of our Company as an employee if you are selected?
How to back charge the Gas turbine generator
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
why we are using Load factor?
Give some example of fault limiting devices?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
