Interested to Buy Any Domain ? << Click Here >> for more details...
Control valve question
what is the meaning of cauge.?what is the use of cauge?
- 1 Answers
- 5472 Views
- I also Faced
- E-Mail Answers
Answer Posted / aftab ahmed mazari
Cages are used in control valves for following purposes:
1. To determine chracteristics of flow.(Equal percentage,
Linear, Quick opening)
2. To avoid flashing and cavitation in control valve.
aftabmazari@yahoo.com
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
defination of radial vibration?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
what are the diff. in servo and regulatory control?
What is the cascade control
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is profibus?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
please send the drdo exam paper
how is work pressure switch& level switch?what is the principle of this?
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
what would be the minimum flow rate that we can measure on rotameter..?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
