Interested to Buy Any Domain ? << Click Here >> for more details...
can we change the range of 3151 model level transmitter of
rosemount make? present calibration range is 1000mmwc and
want to change it to 2000mmwc
- 4 Answers
- 8287 Views
- I also Faced
- E-Mail Answers
Answer Posted / mudassir
yaa you can but you have check the model no. if it is30512G
THEN YOU CAN CALIBRATE IT upto6000mmwc
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
plz send me general of ongc
if my flow is 20000 m3/h than which range of DPT i have to use????
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
what is output of FOUNDATION FIELD BUS transmitter
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What is the difference bitween control net scaner and device net scaner
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
Boolean algebra
Programmable Logic control.
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
2. What is ultrasonic flowmeter?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
