Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh pritech
sfu nothing but as switch fuse unit
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
How DC earth leakage currents can be reduced ?
can any one tell in easy method for circulating current ??
What is cut-off rate?
What are the types of windings according to the construction?
can we synchronize star system generators with delta system transmission line ? and how ?
how to select rating of HT Panel
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
define displacement & magnitude ?
how 650 volts creates? where is use?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
Why cables and busbar both needed in LT Panels?
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
