Interested to Buy Any Domain ? << Click Here >> for more details...
Why DC current is not used in transformer?
- 20 Answers
- 43136 Views
- JK Paper, TCS, I also Faced
- E-Mail Answers
Answer Posted / master ramunni raja.v
When we apply the DC supply to the Transformer there is no
emf is produced. But it act as a ElectroMagnet. Electro
magnet Having Magnetic flux. That flux also can induce the
emf in secondary side. But There is no frequency in the
Secondary side output voltage. So finally the output is also
a DC supply.
EX: We can operate a relay in DC supply. In side the Relay
There is a coil is there.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Transformer how to maintaince a check b check c check d check
how to decide choke rating for drive?
what happened when we supply a dc current in dc motor?? can it worked properly?
How to calculate Ith (I thermal) for curent transformer
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
How two nos. 130 kw D.C motor get synchronise using D.C drive.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
difference between main metering kiosk and check metering kiosk
Define conversion efficiency of a power amplifier.
why we cannot protect 100% winding of an alternator by using differential protection?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
What is frantic effect?
