in three phase circuit neutral failure what happend in homes
Answer Posted / prithiviraj
incase of neutral failure, the all single phase load gets
415v. so all the single phase load get damage
Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how technical is calculated in 11kv line and lt line
is there any phase difference occurs while primary and secondary side mutual induction occurs?
the problem faced on star or delta winding connection??
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
HOW TO CALCULATE S/C,O/C,E/F OF ACB.
What is the Resposiblity of Electrical Utility Engineer
What do you mean by Frame 5 Gas Turbine as well as Mark II.
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
How many devices can be connected in one zone of FACP
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
I want single line diagram for AMF & DG syncronizing panel
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
What is grid collapse? what is the reason for it?