Interested to Buy Any Domain ? << Click Here >> for more details...
I try to check the three phase voltage in multimeter, in
125A isolator switch incommer. first i touch R phase, and
then i touch Y phase using multimeter, the moment i touched,
it blasts and that moment i got blindness. multimeter
selector position is correct(750V AC MODE AND RED PROBE WASS
IN v AND BLACK PROBE WASS IN COM. MODE. COULD ANYBODY GIVE
ANSWER FOR THIS TO AVOID FURTHER ACCIDENTS PLEASE?
- 2 Answers
- 5545 Views
- I also Faced
- E-Mail Answers
Answer Posted / anand yadav
The distance between the live parts would be very small and
meter prob exposed part accidently (prob slipped,sudden
noise,vibration etc.)shorted the two phases,and a results
in a ballast.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is feeder bay?
what is meant by 3rd hormonics ?
What are the transformer losses?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Can anyone explain me about the capacitor calculation
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
what is a reactive power? what is the relation with power factor?
How to Calculate KA Rating of Main LT Panel
what is the difference between Power and Distribution transformers ?
Can you explain about Restricited earth fault protection scheme
Explain marx circuit.
oil cooled transformer
how we can calcultae the short circuit level for bus bar
