Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / syed vikhar ahmad
as we know power factor is the cosine of the angle between
voltage and current and in dc there is 0 angle between
voltage and current so the power factor is always one thats
why we dont discuss power factor in dc.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
State The Difference Between Generator And Alternator?
What is the most accurate way of testing ELCB?ELCB is better than RCD?
full form of flry b
what is the difference between rectifier and converter and commudator?
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
'documenˁ
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
List of equipments required foe industrial repair lab.
Do inductive loads have distorted current waveforms ?
The loads are connected with phase and ground then why current flow as the loads ?
What is mean by STUB protection?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
What will happend if given Vfd out put to step up transformer
An automatic water heater is an example of which type of control system?
