Answer Posted / shariff
Exciter is a DC source voltage for the alternator wdg
excitation, it may a self excited/separately excited DC
genrator or static excitor. This voltage (DC) should be fed
to the alternator through the commutator to produce the AC
Voltage.
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is class of SPD and dittels of all class ?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
Why let through energy not considered for ACB breaker while cable sizing?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
how can i get the formula to find out the cable size if i know the load of main fuse protection.
What is lifting power for 1 wb/m2 and 1 A magnet?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
Why PS class CT is always preferred for Differential protection?
What type of DC motor would you see for a lift?
How much load can be taken for chiller from 1500 kva transformer
can we conduct the swineburne's test on a dc series motor? why?