Interested to Buy Any Domain ? << Click Here >> for more details...
1)how we calculate the drum level? and how we select the
transmitter range?
- 3 Answers
- 9953 Views
- I also Faced
- E-Mail Answers
Answer Posted / jsindrajit
Drum level is measured by measuring the differential
pressure accross two tapings(Bottom & Top)in the drum by
using DP transmitter, whose HP side is connected with the
Taping coming from the bottom and LP side connected with
the taping coming from top.
HP side will have a pressure of Both the Steam Pressure and
Water Level. At the same time LP side will have only Steam
Pressure. Therefore the transmitter will reflect only the
Water level.
The range selection for transmitter depends mainly on three
factors i.e. Drum working Temperature, Drum working
Pressure and Difference of pressure between two tapings.
There are other factors also like Dade band, accuracy,
repeatability, response time etc.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
List three types Level Switches with their working principles
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
How to calculate P,I&D value in PID controller ?
Explain the burnout feature.
Gas equation
draw shematic diagram of c/v positioner(smart type)?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
if my flow is 20000 m3/h than which range of DPT i have to use????
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is the imbustion control loop
send me last 5 years questions asked in rrb chennai, for section engineer
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
what is IEC code in cables & how to selecting cables?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
