Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ramakishore karri
the purpose of the vacuum circuit breaker is to isolate the fault system after the occurance of the fault. So that circuit breaker contacts open, in case of isolator it isolate the power for maintenance of the sub station as u like depends on us and it should not require any relay for finding the type of fault and interrupt the supply. In case of circuit breaker relay is required for finding the type of fault and it interrupt the circuit breaker.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is meant by a stray loss of a induction motor??? What is the equation to find it
what is counter poise conductors
Draw a SLD of HT distribution EB grid up to users Transformer?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
How to address the servo drive for motor
what is the relationship between phase & neutral
What is EMC filter in VVVF Drive ?
Which type of questions well asked. ?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
what curve and rateing would you use for a three phase 0.75kw motor?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
What is the difference between a verilog task and verilog function?
what transformer we used normally and upto which kva?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
