Interested to Buy Any Domain ? << Click Here >> for more details...
If we put a ball(made by metal) of dia 10mm on table of
size 200 mm*200 mm . weight of ball is 10 kg(98.1N) it
should point conact with table than what is the stress
acting on table and why?
- 3 Answers
- 12089 Views
- I also Faced
- E-Mail Answers
Answer Posted / djangokill
Exact mathematical geometries arent followed in real world, and this is actually not a case of point contact. Rather, the ball would depress a certain amount, and a finite small surface would be in contact. For kinematic analysis, we may assume this insignificant and assume it a point contact.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Disposal of radioactive waste materials and spent fuel is a major and important technology. How the waste radioactive material is disposed off ?
what is cyclon vibration effect in turbine
sir, can you give me full idea for computational fluid dynamices and how can work in CFD
What do you understand by catenary cable ?
Define a slined joint?
What is pitting ? How it is caused ?
What is the Self & starter? what does it do in the in Genset
Specific strength of materials is very high when they are in fibre size but lower when they are in bar form why ?
i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
Which reactor produces more fissionable material than it consumes ?
What is hysteresis
What is gravity Dam? What are the forces causing stability?
Discuss how to prepare the M/E in the standby condition
Where pneumatic system is used?
