What are the advantages and benefits of using PLCs to automate
a section of a plant?
Answer Posted / george mathews
Its simple
Plant need to be upgraded and lots of instrument come and go
as technology changes
so
1 :- PLC can be reprogrammed and we can make the new change
and run the plant according to the new condition.
2 :- It can save human hour and Error factor and also
malfunction.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is hp & mp seperator .& what is its working principle ?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is the different between deflection type measurement and null type measurement in RTD?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
How many ohms are required for proper earthing?
How servomotor controls throttle valve of TURBINE?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
How r the calculation of process line mpm.
How to calibrate H2s Dectector
line up procedure for dp type flow transmitter?
what is maxdna ?. explain about the software details.
which type of signal used in instrument?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)