Interested to Buy Any Domain ? << Click Here >> for more details...
1)how we calculate the drum level? and how we select the
transmitter range?
- 3 Answers
- 9954 Views
- I also Faced
- E-Mail Answers
Answer Posted / george mathews
if we are trying to measure the drum level of a drum which
contain water or (H2O) we prefer to use the Hydrastep .
Which is in my knowledge one of the trusted sencer of it
kind .
Anather by using the pressure or more preciesely the DP
transmitter. Here what we do is , we take the connection of
the higher end of the DP Transmitter from d bottm of the
drum and simulteneously we take the connection form the
upper end .where we can find the difference and calculate
the level of water it has got. as during the time of
calibration it is being feeded what ll b d pressure of the
drum when it is full and what is the pressure when it is
empty .
so it ll differenciate the difference between the actual
lever of water level of the drum.
Here the key factor is the density of Any medium , once we
know the Exact density of the Medium we can find the level
easely with the DP Transmitter.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
kindly sent some demo question and answer
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
give some question relative instrument fitter?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How to Calibrate Vortex Flow transmitter in field
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
What is the purpose of bypass valve across AS valve.
sir, give me placement papers and interview quistion of birla group company of copper.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What is force balance principle?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
i am having information technology branh ....... can i prepare for psu exam
