I am pujita completed Electronics and Instrumentation
Engineering.As a fresher i am going to attend the
interviews.Could anybody guide the topics/questions covered
mostly in interviews.
- 11 Answers
- 20536 Views
- I also Faced
- E-Mail Answers
Answer Posted / virendra dharmik
personally milogi to bata sakta hu.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what is the vital subject for scoring bhel exam&what is the question pattern
plz send me general of ongc
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
What is furnace draft control?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is exact time to study dcs and plc cources
How to find out the current of two motors having same power consumption but different RPM?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
