Interested to Buy Any Domain ? << Click Here >> for more details...
Why high Voltages come in multiple of 11, like 11 KV, 33KV,
66 KV, 132 KV etc.
- 11 Answers
- 24659 Views
- I also Faced
- E-Mail Answers
Answer Posted / shibuss
I dis agree with all the answers above.
There is no mathematical/electrical reason.
If form factor (1.11) or multiple is the reason what about
400kv and 765kV (Highest transmission voltages in India)
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
what is W.T?specify the acceptable range?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
How do you select the pickup value of the relay?
How many points does a Circuit can have?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
How do apply electrical 'c'license......pls advice
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
What is the method to solve circuit using source transformation?
What is the efficiency during maximum power transfer?
How would your past experience translate into success in this job?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
Define active filter?
