Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhadrappahr
Fluorescent tube is a gas discharge lamp. It consists of two
filamentary thermionic electrodes mounted at each end of
glass tube. The tube is filled with an inert gas like
mercury at low pressure and sealed. A high voltage is
necessary to start conduction through the tube. To obtain
this high voltage during starting an iron cored choke and
glow type starter are connected in series with filaments.
When the supply is switched ON an arc is struck between the
starter electrodes which causes a current to flow through
the choke and filaments. The filaments get heated up and
emit electrons. After a few seconds the starter electrodes
separates and due to this separation current is interrupted.
This interruption causes high voltage to be induced in the
choke which appears across the filaments of the tube
resulting in discharge through the tube. The gas inside the
tube is ionized and the ionized gas emits ultra-violet
radiation which is absorbed by the fluorescent material
coated inside of the tube this in turn emits light
radiations causing the tube to glow.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
at which voltage level arcing ground is occurs ??????????
How to do stting of vl250 siemens MCCB
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
What is a surge supressor why its is used in synchronous generators
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
What cmos is and its benefits?
please give me all the Alarm .Trip ,Safety Relays & Conditions of UPS Systems mail me on ashokbabunhce@gmail.com
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
what is the breaking capacity and making capacity of circuit breaker and how
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
