Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of improving the power factor (give
technical ans not therotical)
- 2 Answers
- 4864 Views
- I also Faced
- E-Mail Answers
Answer Posted / kavidasan.k
the cosin of angle of voltage and current is called p.f.
the connected loads are may be indutance and resitenance
means it will have lagging p.f(e.g.0.75p.f.)that means u
are consuming only 75% of power but u need to pay 100% for
that in this situation we use capacitor banks(capacitor
have leading p.f.)this capacitor bank will reduce that
lagging,so u r power factor will improve to(e.g.0.95)so u
now consuming 95% power for the same cost as u pay before
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
what percent do you derate your copper wire when you change from copper buss to copper wire
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
Is a d.c.compound motor is use as a booster? how?
When MICC cables used ?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what parameters are should nessary for control technic dc drive(in rolling mills)?
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
what is the excess air in furnace
In parallel operation time both NGR’s close or not close if both close what will happen
why we have and use 3 phase not 2 or 4 or other in power system?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
