Interested to Buy Any Domain ? << Click Here >> for more details...
can we use ordinary transformer in place of
autotransformer?give reasons also
- 1 Answers
- 4631 Views
- I also Faced
- E-Mail Answers
Answer Posted / bosky babu
An auto transformer is used where we need the voltage from 0 to the max value. In an ordinary transformer we can only tap the voltages at few points.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
how we findout a ignater is faulty or not?
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
Why ground terminal is used in pot meter 10k ohms
what is the current density of copper & alluminium.
my diploma certificate in my higher education college
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
