primary of transformer connected to Dc supply in series with
switch, and secondary connected on ammeter, what happens
when swith On and OFF. (or) if continuously On and OFF
- 9 Answers
- 6923 Views
- I also Faced
- E-Mail Answers
Answer Posted / vamsi
because u giving on and off power which is periodic like sinusoidal
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
What is the difference between a 3 winding and 2 winding Potential Transformer
what is the stear deltaprinceple?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
In a flange coupling, the flange bolts are designed for
what is the basic need of domestic loads 1- voltage 2- current
What are all present producing cost of Per KWH of various Fuel?
what is the principle of operation of tungstun bulb ??
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
Is there any abbrevation for STUB in Stub bus protection
witch pump used in wtp
