Interested to Buy Any Domain ? << Click Here >> for more details...
primary of transformer connected to Dc supply in series with
switch, and secondary connected on ammeter, what happens
when swith On and OFF. (or) if continuously On and OFF
- 9 Answers
- 9178 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaansi
there will be deflection in ammeter
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
Define bibo stability.
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
reason of diode failure in alternator
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
Define resonant frequency?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
How to calculate Voltage regulation of 22 KV Over head Line.
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
How to measure the earth resistance value in a concrete pavement(flood light area)?
how to calculate singlephase motor efficiency?
