What is the basic difference between Latches and Flip flops?
- 99 Answers
- 178042 Views
- Bosch, Caritor, D Link, IBM, TCS, Thapar University, I also Faced
- E-Mail Answers
Answer Posted / vinay kumar
latch:-
the simplest type of flip flop ,consisting of two cross
coupled NAND OR NOR universal gates uses latches.it is
bistable digital circuit used for storing a bit or latch are
bistable whose state normally depend on asynchronous inputs.
FLIP FLOP:-
a two states circuit that can remain in either state
indefinitely. also called bistable multivibrator . an
external trigger can changes the output stage. edge
triggered flip flop are bistable device with synchronous
inputs whose state depends on the inputs only at the
triggering transition of a clock pulse . change in the
outputs occur at the triggering transition of the clock.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why the aspect ratio of tv video display is 4:3 or 16:9?
explain the trasistor sizing procedure for a four inputNOR and four input NAND Gate?
Explain the different steps of Commissioning.
Silicon carbide reinforced aluminium metal matrix composites find application in
how does polarised capacitor works?at which situation in circuit it is used
how apb protocol has a minimum power consumption?
What do you mean by operating point?
why cristal frequency is different in microcontrollers and crystal oscillators?
What happens to the conductivity of semiconductor with the rise in temperature? Compare with the conductivity of metals.
why we using different type of microwave antenna we using like one is connected to MMU and one more is connected to other slot what is use of both antenna?
How many maximum slots we can use in ESMA card?
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
WHAT IS DIFFERENCE BETWEEN. WRITE: a+m(2). m = m + 1. + OF THESE TWO IN SAP ABAP
radar
Explain the use of excess-3 code.
