Interested to Buy Any Domain ? << Click Here >> for more details...
What is the min and max ohmic value for earthing?
- 15 Answers
- 40146 Views
- NewTek, Wipro, I also Faced
- E-Mail Answers
Answer Posted / r prakash
The whole list of answers is confusing.
No one is telling the correct values for a normal
Industrial machinery which sometimes includes sophisticated
machinery using Computers and electronics circuit.
I want to check the earthing status of some of the Earths I
did about 5 years ago in my factory.
Can someone help me in this.
R Prakash
rprakash@rataneng.com
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
There is any especial requirement for motor to drive through with VFD?
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
why and where we use early make & late break contacts in protection?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
What is the necessary condition for stability.
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
what is the advantages og idmt relay over magnetic relay??
What are dcs and plc?
